External wall insulation in Aix-les-Bains.
In Aix-les-Bains, good external insulation depends first of all on the house: a 1970s suburban house on the hillsides, a Belle Époque villa near the thermal baths and a town house built on the plot boundary call for neither the same technique nor the same procedures. Atelier NovAlp, RGE CertiRénov certified, studies your façade, prepares the planning file and carries out the insulation with its own teams, from its office on avenue du Grand Port.
Which Aix houses benefit most from ITE?
The Aix basin mixes very different types of building. The suburban houses of the 1960s to 1980s, numerous in Mouxy and on the hillsides, have undecorated façades and often poorly insulated walls: this is ideal ground for ITE, which treats walls, slab edges and corners in one go. The same logic applies to the 1970s chalets on the slopes of the Revard, in Trévignin or Saint-Offenge, where cladding on a frame continues the spirit of the existing building.
The town centre is another matter. The Belle Époque buildings and villas around the thermal baths and the Grand Cercle have mouldings — cornices, surrounds, bands — that an insulation panel would make disappear. On these façades, we instead propose internal wall insulation, a lime insulating render compatible with old masonry, or ITE limited to gable walls and undecorated rear façades.
Then there is the very Aix case of houses on sloping ground: a downhill façade over two storeys, an uphill façade half buried. The insulation does not stop at ground level in the same way on both sides, and it is often at this junction that the final performance is decided.
Planning in Aix-les-Bains: Grand Lac local plan (PLUi), ABF heritage architect and the lake site
ITE changes the external appearance of the building: it requires a prior declaration (déclaration préalable) filed at the town hall. In Aix-les-Bains, the applicable rules are those of the Grand Lac inter-municipal local plan (PLUi), approved on 9 October 2019 for the municipalities of the former Lac du Bourget urban community. It sets, zone by zone, the siting and external appearance rules with which the insulated façade must comply.
Near a historic monument, the ABF heritage architect (Architecte des Bâtiments de France) gives an opinion on materials, colours and joinery, and processing is extended by a month. Some lakeside areas also fall within the listed Lac du Bourget site. For these addresses, we attach render or cladding samples and junction details to the file, so that the opinion concerns a specific project rather than an intention.
Good news for tight plots: Article L.152-5 of the planning code allows the town hall to grant a 30 cm derogation from the siting rules of the local plan (PLU) for external insulation that projects out, on a building completed more than two years ago. This derogation applies neither near historic monuments, nor within a remarkable heritage site, nor to buildings protected by the local plan (PLU).
Wall on the property boundary: insulating over the neighbouring land
In the town centre, where plots are narrow and houses often share party walls, many walls are built directly on the dividing line. Insulating them externally means encroaching on the neighbouring plot. Since the 2021 Climate and Resilience law, Article L.113-5-1 of the construction and housing code opens up a right of overhang of at most 35 cm, where no other solution achieves equivalent energy efficiency without excessive cost or complexity.
The scheme is tightly regulated: the insulation must be fitted at least 2 metres above the ground, unless both owners agree; a prior compensation payment is owed to the neighbour; the agreement is recorded by a notarised deed published in the land register. The owner notifies the project before any work starts, and the neighbour has six months to object on serious and legitimate grounds.
If the façade opens directly onto the street, it is a public land occupation permit that must be obtained from the municipality. We build these procedures into the schedule from the study stage: they set the start date far more than the installation itself.
West-facing façade, sloping base: our installation choices
With the lake to the west, many Aix façades receive the late-day sun, and summer overheating is very real. ITE leaves the mass of the walls on the inside: it retains the night's coolness instead of releasing stored heat. We combine it with external shading on exposed openings and avoid very dark render colours, which stress the finish in the sun.
On houses on slopes, the plinth needs separate treatment: insulation suited to contact with soil on the buried section, protection against splashback at the foot of the wall, a careful junction between the uphill and downhill façades. A damp wall at its foot cannot be insulated as it is: we first look for the cause.
Finally, adding insulation moves the face of the façade: window sills to extend, roof overhangs sometimes too short, rainwater downpipes and shutters to refit. That is why we also examine the roof and joinery — see our pages on roof renovation and window replacement in Aix-les-Bains.
Funding ITE in Savoie in 2026
Key point: in 2026, wall insulation is no longer eligible for single-measure MaPrimeRénov'. It is still funded as part of a major renovation, reserved for homes over 15 years old used as a main residence and rated E, F or G, with a gain of at least two classes and at least two insulation measures. This route requires an independent Accompagnateur Rénov' adviser: we work alongside them and we carry out the works.
The zero-rate eco-loan (eco-PTZ), with no income conditions, and 5.5% VAT on insulation work for a home over two years old complete the financing plan. MaPrimeRénov', the eco-PTZ and CEE premiums require an RGE firm: Atelier NovAlp is certified RGE CertiRénov (no. CR-2026-73-0095).
At département level, the “Savoie Rénov'énergie” grant is suspended pending its revision (position as of July 2026). For neutral, free advice, the France Rénov' service funded by the Département is provided by ASDER (04 56 11 99 00), and the Mes aides France Rénov' simulator gives your up-to-date amounts. For a complete project, see also our page on energy renovation in Aix-les-Bains.
What our teams handle in Aix-les-Bains
A single point of contact from the façade survey to handover: we design, file the permits and fit the insulation with our own teams.
Survey and assessment
Wall type, damp at the foot, condition of the render, length of roof overhangs: we measure before proposing a technique and a thickness.
Planning application
Prior declaration (déclaration préalable), colour chart, junction details and, near a monument, a file submitted to the ABF heritage architect (Architecte des Bâtiments de France).
Overhang agreement
Notification to the neighbour, access agreement and schedule: the right-of-overhang procedures prepared with you ahead of the works.
Rendered ETICS
Insulation bonded and mechanically fixed, reinforced base coat and finish, with specific treatment of the plinth on sloping ground.
Cladding on a frame
Timber or composite on a ventilated air gap, suited to chalets on the slopes of the Revard and to irregular façades.
Joinery and verges
Extended sills, insulated reveals, shutters and downpipes refitted, roof verges extended: the awkward details dealt with straight away.
Towns served for your external insulation works
Regular work in the Aix-les-Bains area, around Lake Bourget and as far as Chambéry — for a town not listed, get in touch.
Frequently asked questions — External insulation in Aix-les-Bains
Let's talk
at the foot of your façade.
Our office is at 198 Avenue du Grand Port, Aix-les-Bains. We come to survey your façade, measure the heat loss and leave with a genuine preliminary external insulation study. First meeting and first estimate: free and with no obligation. Call us on 06 82 32 16 67.